Savage 110 .375 Scope Mount Recommendations

Joined
Jul 14, 2025
Messages
4
Reaction score
5
Just as the title says. I can't seem to find any decent scope mount recommendations. I'm looking to put a Leupold 2x7 or a fixed 2.5 for a Bear / Moose combo and maybe some lighter reloads to .35 Remington level for deer. Because of the action I had to put a picatinny rail. Thanks
 
If you go into the Midway USA website, you can find what would fit your rifle.

 
If you already have a rail on it you have lots of choices. I have a 110 tactical with a rail and use the Warne steel rings. They are a little awkward to install but are rock solid when done. Low rings should work with those scope choices.
 
If you already have a rail on it you have lots of choices. I have a 110 tactical with a rail and use the Warne steel rings. They are a little awkward to install but are rock solid when done. Low rings should work with those scope choices.
I'll check them out, thank you for the recommendation. Because of the long action I'm a little worried the Leupold may not be long enough. I'll measure another one that I already have to confirm.
 
Second recommendation for Warne. I had them on two Savage rifles and they were rock solid once installed. In your case with a Picatinny rail already installed, you can go for a QD set of low rings and be done rather quickly.
 

Forum statistics

Threads
64,533
Messages
1,421,102
Members
130,853
Latest member
GusOShanas
 

 

 

Latest posts

Latest profile posts

bigrich wrote on Bob Nelson 35Whelen's profile.
thanks for your reply bob , is it feasible to build a 444 on a P14/M17 , or is the no4 enfield easier to build? i know where i can buy a lothar walther barrel in 44, 1-38 twist , but i think with a barrel crown of .650" the profile is too light .
Duke1966 wrote on Flanders357's profile.
ok $120 plus shipping
teklanika_ray wrote on MShort's profile.
I have quite a bit of 458 win mag brass, most of it new. How much are you looking for?

Ray H
bigrich wrote on Bob Nelson 35Whelen's profile.
hey bob , new on here. i specifically joined to enquire about a 444 you built on a Enfield 4-1 you built . who did the barrel and what was the twist and profile specs ? look foward to your reply . cheers
 
Top