Correct bullet

Safari Arms Ltd can load up what you need. I called and spoke directly to John and he's a great guy. If he's got it in stock, he'll load it for you. He can also load you a ladder (5 cartridges each of 5 different loads) to see what shoots best and then do a larger run of the good stuff. Best of luck.

Personally I'm a fan of the 300 grain TSX in 375, but Swift A-Frames, Norma Oryx or Federal TBCC will all get the job done.

https://www.safariarms.com/
 
I have a Weatherby Mark V rifle. IMR 4350 is what I was going to try with the Swift 300's, and since it is a weatherby, will probably be closer to max. Most Weatherby I have shot prefer loads up near the top end.
My .375 H&H is a Mark V also and I've got to 79gn of AR2209 (H4350) so far in the brass from the Federal ammo previously mentioned with a 300gn Woodleigh PP. No pressure signs so I need to load up more at this and chronograph then fine tune from there if required.
 

Forum statistics

Threads
64,484
Messages
1,420,008
Members
130,592
Latest member
AveryHagel
 

 

 

Latest profile posts

teklanika_ray wrote on MShort's profile.
I have quite a bit of 458 win mag brass, most of it new. How much are you looking for?

Ray H
bigrich wrote on Bob Nelson 35Whelen's profile.
hey bob , new on here. i specifically joined to enquire about a 444 you built on a Enfield 4-1 you built . who did the barrel and what was the twist and profile specs ? look foward to your reply . cheers
wheelerdan wrote on Jager Waffen74's profile.
Sir, I think I have been writing to you about the purchase of the HK 639 rifle under an email "Tt Jake." If this is you, then I am truly interested. I am just trying to verify identify. Tt Jake is asking for a cash transaction. No disrespect intended, Just trying to verify who I am talking to. Thank you. Respectfully. Dan
 
Top