Waterbuck

Do I measure through the ridges or what?
 
Dox,
Not sure what you exactly mean by "measure through the ridges" but the length of the waterbuck horn is measured from the base of the horn along the inside/front of the curved horn to the tip. The tape measure is placed against the horn following the curve however not pressed into the ridges.

1220d1258137899-waterbuck-hunting-waterbuck.jpg
 

Attachments

  • hunting-waterbuck.jpg
    hunting-waterbuck.jpg
    35.9 KB · Views: 324
Last edited by a moderator:
SCI current number ONE Waterbuck

Don't know the measurement of the horns, but no doubt that they are each over 33 inches in length. This is the number ONE Common or Ringed Waterbuck in the SCI record book. This Waterbuck was taken in November of 2005 with Matswani Safaris in South Africa, it broke the previous Waterbuck record by 2 inches.

1221d1258144624-waterbuck-1108882.jpg
 

Attachments

  • 1108882.jpg
    1108882.jpg
    83.6 KB · Views: 315
Last edited by a moderator:
I have a 30 inches waterbuck, hunted last August in Northern Cape province, with a 375 H&H.

Not a monster, but a really mature bull and a very interesting hunt. Very dirty shooting among the branches and leaves...

16gzm8l.jpg


I hope you like it.
Jose
 

Attachments

  • 16gzm8l.jpg
    16gzm8l.jpg
    49.7 KB · Views: 254
Louis

Fine Waterbuck, what caliber did you use ??

Monish
 
I use a CZ caliber 375 H&H, 235 grains soft point.
I usually prefer 375 H&H for dirty shots between the bush... because it is more difficult to stop accidentaly with any little obstacle (leaves, little branches etc...)

You kow that the main problem in these dirty shots is the stalk, because you can´t see well the animal... and at the end you shoot more or less when you think is the body of the bull... not guaranteed perfect shoot placement.

This one received the bullet in the chest, we were 50 m from him, just in front of him... and fell down onhis tracks... not a single step. ;)

fc40zt.jpg


Best regards
Jose
 

Attachments

  • fc40zt.jpg
    fc40zt.jpg
    30.8 KB · Views: 226
Heeler,

Good buck !!

Monish
 

Forum statistics

Threads
68,640
Messages
1,527,361
Members
155,722
Latest member
LarhondaQf
 

 

 

Latest posts

Latest profile posts

buckstix wrote on 450 Dakota's profile.
SENT THIS PM YESTERDAY ..

I will take a set .. I would take more than one set if you have more.

BUCK STIX - PO BOX 3 - NEENAH WI 54957-0003
920-450-0723
Redfishga1 wrote on Steve D's profile.
ill take both of the 375 woodleigh hydros
AfricaRob wrote on Luminous Ham's profile.
See you are from Denmark - see quite a few Danes where I stalk in Scotland - great hunters.
The Harkilia stuff works well in Africa - I have a bit for use here in UK.
I am again looking for 600 Nitro dies preferably RCBS 1 inch. The set I purchased previously are 1 1/2 inch and do not fit my die. Another member has graciously taken them off my hands. If anyone happens to have a set of 600 Nitro Dies that will fit my Rockchucker Supreme RCBS press, please shoot me a message and thanks in advance for any assistance you may have to offer!
 
Top