Crossbolt Wrench

[CoElkHunter]

Where could I find a good crossbolt wrench for removing and/or tightening the stock crossbolts on my CZ and Interarms Whitworth rifles? Thanks!

 

[Mekaniks]

Like this one??
https://www.brownells.com/gunsmith-...ches/mauser-98-cross-bolt-wrench-prod416.aspx

 

[CoElkHunter]

Like this one??
https://www.brownells.com/gunsmith-...ches/mauser-98-cross-bolt-wrench-prod416.aspx

Yes, I looked at that one but one of the reviews stated the pins were soft metal? It’s back ordered but if I can’t find something else I’ll order it. Couldn’t find anything on GB or Midway? Thanks!

 

[375 Ruger Fan]

I read on another blog where someone suggested snap ring pliers as an alternative. Just a matter of getting the right size. You might check a local autoparts store or Lowes/Home Depot.

 

[CoElkHunter]

I read on another blog where someone suggested snap ring pliers as an alternative. Just a matter of getting the right size. You check a local autoparts store or Lowes/Home Depot.

Thanks, I’ll check around. I’m not in a hurry, but I’m thinking at the very least the crossbolts have to be checked for tightness every once in a while?

 

[Wyatt Smith]

I’ve used needle nose pliers.

 

[Ray B]

I'm not familiar with the crossbolt heads on those rifles. If they have two small holes in them you may be able to use a spanner wrench with pins set to go in the holes, then turn the wrench to tighten them.

 

[Grouser]

I have used these:

Snap Ring Pliers with Interchangeable Heads

Amazing deals on this Snap Ring Pliers With Interchangeable Heads at Harbor Freight. Quality tools & low prices.

www.harborfreight.com

I didn't try to get them brutally tight.....

 

[John P.]

I make them, if I can remember I will take a photo tomorrow and show you how to make one. Easy job.

 

[Nevada Mike]

The tool is very similar to the tool used to remove striker bushings on shotguns and double rifles. I would call Brownell's... perhaps they can suggest a source.

Seems that trying to use the 'wrong' tool will risk damage to the pins. I doubt that a loose cross pin would cause any accuracy problems... the pressure on the pin is lateral and the pins are inletted tightly and not tapered.

 

[BourbonTrail]

CEH, something like this may work:

Amazon.com

 

[krish]

Where could I find a good crossbolt wrench for removing and/or tightening the stock crossbolts on my CZ and Interarms Whitworth rifles? Thanks!

There are different cross bolt wrenches. One dont fit
all. I had my Machinist friend make one for me.
Krish

 

[John P.]

On the left is a Brownells, on the right is one I made using a 1/2" grade 8 bolt for material.

Note the one I made has holes of two different pin spacings. Move the pins as required.

Simple job for the lathe and the vertical mill.

 

[CoElkHunter]

On the left is a Brownells, on the right is one I made using a 1/2" grade 8 bolt for material.

View attachment 439222

Note the one I made has holes of two different pin spacings. Move the pins as required.

View attachment 439221

Simple job for the lathe and the vertical mill.

Very nice!