Wanted Fed 215 Primers Or Other Large Magnum Rifle Primers

fourfive8, no worries on my end, a good discussion always trumps the thread's intent or placement. There is another forum I frequent where everyone has to jump into the classifieds to say what a great gun/deal/seller is, and how they would buy it if only for money/laws/wife. Drives me nuts. Not this thread at all, which has been very interesting to me.

To piggyback for ET1775, about the best way to follow fourfive8's advice is to never handle your primers. There really is no reason. They should go from the tray to the loader, without ever being touched by your hands. Safer for them, safer for you.

I'm looking forward to trying the 34's here in a bit.
 
fourfive8, no worries on my end, a good discussion always trumps the thread's intent or placement. There is another forum I frequent where everyone has to jump into the classifieds to say what a great gun/deal/seller is, and how they would buy it if only for money/laws/wife. Drives me nuts. Not this thread at all, which has been very interesting to me.

To piggyback for ET1775, about the best way to follow fourfive8's advice is to never handle your primers. There really is no reason. They should go from the tray to the loader, without ever being touched by your hands. Safer for them, safer for you.

I'm looking forward to trying the 34's here in a bit.
I ordered some of the CCI #34 as well. I bought a couple primer flippers and an extra LR primer tube for my bench primer, I will mark them small rifle, large rifle and magnum so I will not ever load the wrong primers. Also, dedicated priming area, will not handle them unless I have to and I have nitrile gloves for that. I am OCD leaning enough to really enjoy this pursuit and I would like to keep my eyes and fingers for the long run. Now if anyone has a lead on Fed #210M I am all ears! I am up to my neck in small rifle primers.
 

Forum statistics

Threads
64,650
Messages
1,423,614
Members
131,547
Latest member
TeganHarde
 

 

 

Latest profile posts

bigrich wrote on Bob Nelson 35Whelen's profile.
thanks for your reply bob , is it feasible to build a 444 on a P14/M17 , or is the no4 enfield easier to build? i know where i can buy a lothar walther barrel in 44, 1-38 twist , but i think with a barrel crown of .650" the profile is too light .
Duke1966 wrote on Flanders357's profile.
ok $120 plus shipping
teklanika_ray wrote on MShort's profile.
I have quite a bit of 458 win mag brass, most of it new. How much are you looking for?

Ray H
bigrich wrote on Bob Nelson 35Whelen's profile.
hey bob , new on here. i specifically joined to enquire about a 444 you built on a Enfield 4-1 you built . who did the barrel and what was the twist and profile specs ? look foward to your reply . cheers
 
Top