on a lighter note...

197B2C51-6AF3-4219-AD9A-DFC8AABBBAD6.jpeg
 
Has anyone ever seen the episode of myth busters where they tested this. Allegedly some man tried this on his pickup, then got shot in private parts and wrecked.

If you noticed, the bullet stayed in place and the case ruptured. Same if you throw a loaded cartridge into a fire, the case will rupture while the bullet will stay close to the same location where it was in the fire. It does this because the bullet is heaver than the case and stays relative in the same location as to what the case does, it may move some but not much.
 
If you noticed, the bullet stayed in place and the case ruptured. Same if you throw a loaded cartridge into a fire, the case will rupture while the bullet will stay close to the same location where it was in the fire. It does this because the bullet is heaver than the case and stays relative in the same location as to what the case does, it may move some but not much.
That is true, especially with small ammo held in place. But if some idiot chucks a 375 H&H into a fire pit I happen to be sitting by, I will not be hanging around to document the redundancy of the theory. ;)
If a bigger cartridge blows out on the other side of the case from my position, there’s a good chance I’ll be wearing it…and it might just be a little warm.
 
That is true, especially with small ammo held in place. But if some idiot chucks a 375 H&H into a fire pit I happen to be sitting by, I will not be hanging around to document the redundancy of the theory. ;)
If a bigger cartridge blows out on the other side of the case from my position, there’s a good chance I’ll be wearing it…and it might just be a little warm.
I don't even hang around when they throw a 22 Lr into a fire. Flying brass isn't my idea of a fun time
 

Forum statistics

Threads
64,493
Messages
1,420,323
Members
130,686
Latest member
KristalHen
 

 

 

Latest profile posts

bigrich wrote on Bob Nelson 35Whelen's profile.
thanks for your reply bob , is it feasible to build a 444 on a P14/M17 , or is the no4 enfield easier to build? i know where i can buy a lothar walther barrel in 44, 1-38 twist , but i think with a barrel crown of .650" the profile is too light .
Duke1966 wrote on Flanders357's profile.
ok $120 plus shipping
teklanika_ray wrote on MShort's profile.
I have quite a bit of 458 win mag brass, most of it new. How much are you looking for?

Ray H
bigrich wrote on Bob Nelson 35Whelen's profile.
hey bob , new on here. i specifically joined to enquire about a 444 you built on a Enfield 4-1 you built . who did the barrel and what was the twist and profile specs ? look foward to your reply . cheers
 
Top