Something a little different

AZDAVE

AH ambassador
Joined
Jul 26, 2013
Messages
5,626
Reaction score
12,641
Media
215
Hunting reports
Africa
10
Hunted
South Africa,Namibia, Mozambique, Alaska,lower 48
For Sale a Ruger 77 Custom in 450 Marlin.

Will good reloading procedures you can get 458 American loads out of it.

That said I have only shot factory 350gr loads out of it. The peep sight is zeroed with that round.

There is a small chip at the rear tang area where I needed to provide a small relief. The chip was glued back in .

Stock is a high grade walnut Boyds stock.

Asking $1950 shipped to your FFL.

IMG_4794.JPG
IMG_4796.JPG
IMG_4797.JPG
IMG_4798.JPG
IMG_4799.JPG
 
Last edited by a moderator:
Just a note about butt plates and length of pull. I ran both of my .458 American's with Neidner checkered steel butt plates. I never thought it kicked hard, except for with the 500gr. Hornady and 510gr. Winchesters. I ran both of those at 2,059fps. av. with both IMR4320 and H335.
If you want data for the .450 Marlin on a bolt gun, just PM me. I put over 15,000 rounds through mine in testing.(& some NA hunting)
 

Forum statistics

Threads
68,617
Messages
1,526,674
Members
155,383
Latest member
CristineP8
 

 

 

Latest profile posts

buckstix wrote on 450 Dakota's profile.
SENT THIS PM YESTERDAY ..

I will take a set .. I would take more than one set if you have more.

BUCK STIX - PO BOX 3 - NEENAH WI 54957-0003
920-450-0723
Redfishga1 wrote on Steve D's profile.
ill take both of the 375 woodleigh hydros
AfricaRob wrote on Luminous Ham's profile.
See you are from Denmark - see quite a few Danes where I stalk in Scotland - great hunters.
The Harkilia stuff works well in Africa - I have a bit for use here in UK.
I am again looking for 600 Nitro dies preferably RCBS 1 inch. The set I purchased previously are 1 1/2 inch and do not fit my die. Another member has graciously taken them off my hands. If anyone happens to have a set of 600 Nitro Dies that will fit my Rockchucker Supreme RCBS press, please shoot me a message and thanks in advance for any assistance you may have to offer!
 
Top