on a lighter note...

290745778_10227879877572438_8821922066437416868_n.jpg
 
A brief history of the evolution of surgery. Sounds like surgeons were moonlighting a blacksmiths to make their own tools. No wonder some surgical implements look like torture devices.

Even Australian hospitals use the Otis Elevator so I'm concerned about the intelligence of medical staff , including the surgeon sending nurses on a wild goose chase.
Very much so and more recently than you would expect. You can gas sterilize pretty much anything so we occasionally use hardware store items. My favorite is a soup spoon from the cafeteria used to retrieve bladder tumor chips from the drainage bag. I have a partner who made a suprapubic catheter guide in his garage by taking a standard stainless dilator and bending it into a semicircle on a vice in his shop, then drilling a hole through the end for suture.

In terms of intelligence, as much as we would love to believe otherwise, the hospital is just a much a cross section of the population as anywhere else. I once had a trained RN refuse to cut a suture to 8 inches because the sterile or ruler "only goes to 6 inches"
 
The camgina is the tight fitting fluid warmer that the DaVinci robotic camera lense slides into to keep it at body temperature when out of the abdomen so it won't fog on reentry.
Ever notice that a lot of orthopedic surgeons are woodworkers?
 

Forum statistics

Threads
68,676
Messages
1,528,024
Members
156,036
Latest member
EarlFisken
 

 

 

Latest profile posts

buckstix wrote on 450 Dakota's profile.
SENT THIS PM YESTERDAY ..

I will take a set .. I would take more than one set if you have more.

BUCK STIX - [redacted]
Redfishga1 wrote on Steve D's profile.
ill take both of the 375 woodleigh hydros
AfricaRob wrote on Luminous Ham's profile.
See you are from Denmark - see quite a few Danes where I stalk in Scotland - great hunters.
The Harkilia stuff works well in Africa - I have a bit for use here in UK.
I am again looking for 600 Nitro dies preferably RCBS 1 inch. The set I purchased previously are 1 1/2 inch and do not fit my die. Another member has graciously taken them off my hands. If anyone happens to have a set of 600 Nitro Dies that will fit my Rockchucker Supreme RCBS press, please shoot me a message and thanks in advance for any assistance you may have to offer!
 
Top