on a lighter note...

z493278064_667673402824824_6305795669674438389_n.jpg
 
I know a lot of them have been dispatched by a frustrated deer hunter with a cartridge totally over-suited to the task because they couldnt keep their little chattering mouths shut.
Little buggers have snitched on me more than once.
 
I'm learning to tolerate them. My last buck was killed because those little early warning systems went off as he was walking towards the shooting lane.
Just seen on the back of a cesspool cleaning truck: Another load of politician's promises.
 
Ooh ooh wait...correolis effects?....flat earth?... :unsure::unsure::unsure:....rainbows are arched.....wouldn’t the sun's rays be reflected at a known angle at a certain given time on the flat earth create striaght line prisms that would be bent "dancing" by variants of wind speeds and directions at different altitudes?

:unsure::unsure::unsure::unsure:.....
Much like a flashlight hitting a mirror at just the right angle?.

LMFAO.....
And that is why it's in the humor section....
 
Nonsense... there's:
Canada, BC, Alberta, Saskatchewan
Idaho,
Oregon (?),

It's deer season somewhere.
1. Ive been to Canada once and have no wish to visit again.

2. Out of state tags tend to be costly. Although i admit i havent looked too deep into it. A trip to Idaho wouldnt be bad if the tags arent too expensive.
 

Forum statistics

Threads
64,644
Messages
1,423,446
Members
131,483
Latest member
CatalinaTh
 

 

 

Latest profile posts

bigrich wrote on Bob Nelson 35Whelen's profile.
thanks for your reply bob , is it feasible to build a 444 on a P14/M17 , or is the no4 enfield easier to build? i know where i can buy a lothar walther barrel in 44, 1-38 twist , but i think with a barrel crown of .650" the profile is too light .
Duke1966 wrote on Flanders357's profile.
ok $120 plus shipping
teklanika_ray wrote on MShort's profile.
I have quite a bit of 458 win mag brass, most of it new. How much are you looking for?

Ray H
bigrich wrote on Bob Nelson 35Whelen's profile.
hey bob , new on here. i specifically joined to enquire about a 444 you built on a Enfield 4-1 you built . who did the barrel and what was the twist and profile specs ? look foward to your reply . cheers
 
Top