.375 HH question

Hmm? :)
You can try chucking the plug in a drill and spinning the cavity on a cone shaped piece of 200-400 grit paper to smooth the inside surface. Looks like a super close fit of plug on ogive and a turning ridge on the contact surface may be “grabbing” the bullet. Also there should be enough neck tension to prevent pulling the bullet back out of the neck once seated.

Other than that... got me?
 
Are the bullets being pushed into the case and then drawn back out when you lower the ram?
It is. It looked to me from the inside of the neck that it had gone into the case and was just pulled right out. Told my dad it seems with me, nothing is ever just plug and play. Same reason I don’t ever attempt DIY projects around the house.
 

Forum statistics

Threads
53,624
Messages
1,131,367
Members
92,680
Latest member
ChadSimpso
 

 

 

Latest posts

Latest profile posts

Impact shots from the last hunt

Early morning Impala hunt, previous link was wrong video

Headshot on jackal this morning

Mature Eland Bull taken in Tanzania, at 100 yards, with 375 H&H, 300gr, Federal Premium Expanding bullet.

20231012_145809~2.jpg
 
Top