nztimb
AH ambassador
I had an email from a gunshop a few hours south of me asking if I would do some remedial work on a replacment TSK stock that didnt fit the action as neatly as the original on the 694 shotgun action. Rather than a heritage fit of about a 1/2 mm there was over 2mm in places and where the action had a curve that made a soft flute down either side of the wrist there was a sharp edged flat water table. Going to be some slow carefull work to get it all looking right and matching the finish. Wont get to it this week and probably not next week either but by then I will hae to have a serious look at it.
