Reloader 19

Pheroze

AH ambassador
Joined
Jul 6, 2013
Messages
5,484
Reaction score
9,696
Location
Ontario
Media
100
Articles
32
Hunting reports
Africa
2
USA/Canada
6
Member of
OFAH, DSC
Hunted
South Africa, Canada, USA
I am running low of H4831, which I use for the 308 Norma Mag, and I found that the local shop is too. So, I am going to give Reloader 19 a shot as it is used in the Woodleigh and Nosler manuals. Probably smart in this climate to have alternatives anyways. Any thoughts on this powder? The company is Swiss it seems.
 
It’s magical stuff. Remember, it’s often used in guns that also use 4350.

the difference? All things being equal, the powder that requires the least amount of grain charge to achieve the velocity has less recoil.

Put another way, it kicks less than IMR4350
 
Its burn rate is more similar to IMR4831, AA3100 or Ramshot Hunter. Good stuff if you can find any.
It’s magical stuff. Remember, it’s often used in guns that also use 4350.

the difference? All things being equal, the powder that requires the least amount of grain charge to achieve the velocity has less recoil.

Put another way, it kicks less than IMR4350
My experience is quite different. It being slower than 4350 and it is, it takes more powder to achieve the same velocity and that would negate any felt recoil difference if one even existed. No one can tell the difference in recoil in a few grains of powder one way or the other, or as Jack O'Conner might say, "only a guru of heightened awareness would notice:.
 
Reloader or Reloder?

I think the latter is the correct spelling of the product line, but it gets misspelled by autocorrect a lot. Even in company ads, you see it spelled both ways.

1602418138145.png
 
Another Alliant powder to consider, if available, would be 4000MR. I use it with the 300WM & 180gr AF. When it first came out I talked with a tech at Alliant, he thought to have a burn rate between RL19 & RL22. I have had good luck with the powder in 300WM, 6mm Rem & 8x68s.
 
I have used it in my 338 win mag with good results
 
I use it in 308 win, mostly for loads I run in a gas gun. It is very useful and one of the powders I try to stockpile.
 
I use it in 308 win, mostly for loads I run in a gas gun. It is very useful and one of the powders I try to stockpile.
What type of gas gun? Not an M14 type I hope.. or an M1.
 
I think Rel 19 is listed as a good powder for the 308 NM. Just not many of those around :)
Some of my best 30-06 loads with 165 and 180 gr bullets have been with Rel 19. Common for folks who have pet loads with IMR 4350 to sooner or later try Reloder 19. I certainly would give it a try in the Norma Mag if H4831 or H4831SC became nonexistent.

If I hadn't consolidated and simplified all my powders into primarily a selection of Hodgdon Extremes, Reloder 19 would be one of the top contenders for most used and most useful for my calibers.
 
Last edited:
NM? What is that? NM usually means National Match.
 

Forum statistics

Threads
68,566
Messages
1,525,293
Members
154,824
Latest member
SuzannaPir
 

 

 

Latest posts

Latest profile posts

Redfishga1 wrote on Steve D's profile.
ill take both of the 375 woodleigh hydros
AfricaRob wrote on Luminous Ham's profile.
See you are from Denmark - see quite a few Danes where I stalk in Scotland - great hunters.
The Harkilia stuff works well in Africa - I have a bit for use here in UK.
I am again looking for 600 Nitro dies preferably RCBS 1 inch. The set I purchased previously are 1 1/2 inch and do not fit my die. Another member has graciously taken them off my hands. If anyone happens to have a set of 600 Nitro Dies that will fit my Rockchucker Supreme RCBS press, please shoot me a message and thanks in advance for any assistance you may have to offer!
I have not posted any items for sale on this forum and will not every put anything for sale. My account was hacked and I've worked with the admin to get things shut down.
 
Top