annealing

[Bob Nelson 35Whelen]

This is true. With the go-to Hornet powder (Hodgdon Lil'gun) however, you can't get enough powder in the case for it to be an issue unless using unusually heavy ( >55gr) bullets. Typically I load 12 gr Lil'gun with 50 gr Hornady SP bullets

@Rimshot
I got told Lil' gun was the ducks guts in the K Hornet. To me it was a disaster.
I loaded up 5 cases with the recommended 13grains in the K Hornet. I fired three shot and called it quits. I know the chronograph was correct because I always check it with known velocity 22lr subsonic ammo at 1,070fps.
My velocities for the lil gun load with a 40gn VMAX varied from 3,300fps to 2,800fps. With results like that I was very confused,annoyed and pissed off. The temp on the day of testing was 36 Celcius. I do all my load development in summer that way my loads are safe year round.
Bob

 

[Bob Nelson 35Whelen]

False shoulder vs long seated bullet:
The shoulder will generally give a more precise case after firing because the shoulder will hold the case more firmly against the push of the firing pin than a bullet which can slide back into the neck or further imprint on the rifling. That said, the differences are miniscule.

@Ray B
This is true only in rimless cases that head space off the datum line on the shoulder
The Hornet is a rimmed case so headspaced off the rim.
The beauty of the K Hornet is in some older Bruno ZKKs they can have headspace issues . Conversion to the K Hornet and using the datum line instead of the rim can assist in this issue.
When I had my k Hornet built I only use Remington brass so had my lowall spaced for the rim thickness of that brass.. That made it one very accurate little rifle. It will put 3 shots into a group that can be covered with the base of a Hornet case and if I do my part it will do the same for 5 shots. What's not to like.
Bob

 

[Bob Nelson 35Whelen]

So?? Best accuracy and case life occurs when chamber fit of the cartridge is based on the neck-Magnum, rimless or rimmed.

@Ray B
Yes and no
That's why anal rimfire competition shooter measures the thickness of the rim to give them the best accuracy
Rimmed cases space off the rim but on rare occasions using the datum line ( if the case allows) can be beneficial to reduce incipit head seperation as well
All my rimmed cases are headspaced off the rim for minimum headspace including my old 303.
Bob

 

[Bob Nelson 35Whelen]

Well, a K hornet has a shorter headspace than its parent ayway, so you are already crushing the case 0.004 when you close the bolt. Creating a false shoulder is a total waste of time.

@5shot
How can the headspace be shorter on the K Hornet compared to the standard Hornet when both headshot in the rim???
Yes the case overall length becomes fractionally shorter.
In my 10 years with the K Hornet creating a false shoulder has been if great benefits because I lose less cases when fire forming. That little thin walled case changes shape in a big way and anything I can do to help and prevent cases splitting I will do.
I do the same when forming my 25-303 cases. Capacity goes from 47 gn before forming to over 60 gn so anything to reduce strain on the case during forming can only be good
Bob