Shims under two piece mounts?

Discussion in 'Gunsmithing' started by Ray B, Feb 4, 2019.

  1. Von S.

    Von S. AH Fanatic

    Joined:
    Aug 26, 2018
    Messages:
    551
    Likes Received:
    536
    A competent machinist....and it doesn't have to be a gunsmith.....can cut your bases at the correct taper instead of doing a mickey mouse hardening goo job to go along with more hardening goo in your now oval hole lapped rings.

    The Burris insert rings are the best thing I've heard so far.

    A little math, an accurate set up and it can be done right the first time and you'll be much happier in the end.
     

Share This Page

 
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice