Ruger RSM Uh-oh?

The listing .. same thing I noticed on the RSM here.

ruger rsm crack 1.jpeg

ruger rsm crack.jpeg
 
Flaking??? What flaking?? I see nothing but a couple of small ding/dents.
 
Flaking??? What flaking?? I see nothing but a couple of small ding/dents.
I found this after years of storage on mine. Never noticed it post shooting but was concerned none the less until a gunsmith tore it apart. It's on the above listing ..

1717082489870.png
 
Thats from set back usually, from the tang.
 
@Woodcarver & another source have the same idea, if the aesthetics bothered me or worsens. Foremost, there was no damage to compromise integrity ..
 
It appears to be about to flake out a minor chip. Not a deal breaker. If it did chip out AND you found it, would be an easy acraglass fix IMO. I might be tempted to tape off area, and apply acraglass liquid thinned 40% with acetone which will soak in like water, but leave behind acraglass. Then do a careful spot refinish? But, it's not my gun. Might consider relieving the area behind the tang a TINY bit.
 

Forum statistics

Threads
64,635
Messages
1,423,369
Members
131,448
Latest member
BeatrisGeo
 

 

 

Latest profile posts

bigrich wrote on Bob Nelson 35Whelen's profile.
thanks for your reply bob , is it feasible to build a 444 on a P14/M17 , or is the no4 enfield easier to build? i know where i can buy a lothar walther barrel in 44, 1-38 twist , but i think with a barrel crown of .650" the profile is too light .
Duke1966 wrote on Flanders357's profile.
ok $120 plus shipping
teklanika_ray wrote on MShort's profile.
I have quite a bit of 458 win mag brass, most of it new. How much are you looking for?

Ray H
bigrich wrote on Bob Nelson 35Whelen's profile.
hey bob , new on here. i specifically joined to enquire about a 444 you built on a Enfield 4-1 you built . who did the barrel and what was the twist and profile specs ? look foward to your reply . cheers
 
Top