Nevada Mike
AH legend
- Joined
- Jan 9, 2019
- Messages
- 2,191
- Reaction score
- 4,780
- Location
- S.E. Arizona
- Media
- 31
- Hunted
- Arizona, California, Nevada, Washington, Oregon, Idaho, Montana, So. Dakota, No. Dakota, Texas, Colorado, New Mexico, Michigan, Saskatchewan, Old Mexico, British Columbia, Tanzania
I try to prep all my cases the same and NEVER assume that new cases are OK to load. I FL resize new cases, measure them and use my old Herter's case trimmer with the correct pilot (it is just like the newer Forster trimmer). I deburr each case and measure them all again before loading.
I have had new brass from various manufacturers (especially lately with the shortages) and have found some cases with burrs, dents and out of square case mouths. So I correct all the cases BEFORE I start reloading.
I have had new brass from various manufacturers (especially lately with the shortages) and have found some cases with burrs, dents and out of square case mouths. So I correct all the cases BEFORE I start reloading.
