Bench setup

[Rumrunner]

May be a little homemade but it saves space.

 

[Firebird]

Doubled up wafer is a good idea-I was thinking 2x10 under your front edge would add stiffness but the wafer looks well planned and executed for that purpose. Lots of brass to get filled up there!

 

[Rumrunner]

Two 1/2 or 3/8 inch plywood glued and screwed together. Then 2x4s where the stress is applied.

 

[DG870]

When moving around for work we lived in a trailer house for a couple of years. I used an old Black and Decker workmate with a 3/4 inch plywood c clamped to the top with the edge reinforced with a 2x4 as a reloading bench. It’s whatever works for you to keep you in ammo.

 

[Hooked Now]

Looks great and smart idea. Only suggestion I'd add is a little lip on the sides and back to keep small stuff from rolling off. Maybe thats just me that has that problem...

Well done!

 

[steve white]

I might wish to clamp it to the saw horses just to keep the backside from tipping up if you really have to bear down on that handle?