Recent content by J.J. Kelly

with .300 prc the shoulder is a little far back, so size larger to .40 or .416 and then when you size it you have made a false shoulder, good to shoot. after that perfect brass.

midway usa right now has .300 prc easy fix

Next: part of your neck is .375 the other is .30, now anneal neck. Next I use a .338 expander ball before going to .375. Once this is done load normally ( not max ) remember to work up loads because your using different brass. Other brass may require some other operations, on a bet I made...

take .300 win mag, at belt .532 above bely .511, the body is not going to touch inside chamber. Take form and trim die or fl sizing die without stem, don't turn it down all the way. size the case, the bolt should not close because you are slowly going to turn die down until bolt closes tight...

My equipment: rcbs rockchucker press, rcbs fl sizing die, rcbs seat die, hornaday form and trim die, lee factory crimp die and rcbs mandrel .30 to .40 cal expander. The most imortant thing is to have 0 headspace. This is not for folks that just started reloading. The brass that works best is...

many years ago when I couldn't get brass for my .375 ruger a guy on long range hunting showed he made brass from .300 win mag. He also showed he was using 8x68mm and cut brass in half to show the area above belt was soild. My gun is a ruger 2008 model no brake SS with factory black coat 20"...

Hello, I see that many people on many web sites can't find .375 ruger brass. I can not take credit for this but you can make .375 ruger from any belted mag brass. If your interested I will go into detail.