Elkbugling
AH member
Could you neck up 416 Weatherby brass to 500 A Square? It would have to be done in several steps, but could it be done/would it work?
Thanks
Thanks
Its super easy to neck up 460 Weatherby brass. Just run them through the sizer die and bingo bingo you are good to go.It would be alot easier to use .460 Wby brass
If you tried it with 416 brass you should anneal - open it to .45 cal first - anneal and then go to .500 - that is how I would try it if I couldn't get .460 brass.
Also look here:
https://www.rccbrass.com/product/500-a-square/
Very happy with my lot so farAnyone have experience with the above-referenced company for brass quality?