Richrds's Microfit. You can send them your blank and get whatever style you want. I sent a walnut blank to have a Remington SA inlet with rollover cheekpiece and sporter barrel contour. They did a good job. Just needed to do the final finishing and install pillars.
From their FAQ:
12) Can I send you a piece of wood to have cut into a stock in one of your styles?
Yes, we can cut your wood into any one of our stock style's. The dimensions of the blank need to be as follows: Minimum 32" long, Minimum of 6" wide at the butt, 2" wide at the forearm, and 2" thick. This is the absolute minimium size to produce a stock from it. A normal size blank would measure 34" Long, 6 1/2" wide at the butt, 2 1/2" wide at the forearm, and 2 1/2" thick. Please note: If your blank measures 2 1/4" thick, there may be a few flat spots on the stock but can be rasped out and still be shaped normally by the customer.
http://www.rifle-stocks.com/actions_available.htm
Edit: I have the rifle here. I will take a photo later and post it.