Recent content by Marlwin

Received a very nice stock today. Unfortunately it was for a Ruger Long Action. I realized it right away as I was taking it out of the box and noticed there was no foretip. Third time around is hopefully a charm!

Got the 1153530 stock I ordered from Numrich's in short order (about 3 days) and sent it back the very same day. The stock was beautiful.... except there were a series of small knot holes right where the barrel lug fits into the stock on the forearm. Fearful that that would be a contact point...

No...I am not Heisenberg

I kept asking the young lady at Ruger regarding those bottom fore-end screws and she said 95 inch/pounds. It does seem high but isn't there a brass insert to prevent compression? What's the story behind your original stock? If I had half a brain perhaps I should have asked if your old stock was...

Nailed the 1153530... I was afraid they were going to be out. The torque setting is 95 inch/pounds for the front mounting screw which is accessible under the front part of the magazine hinge and the others forward of that. The specific screw setting for the rear mounting screws (DO4802 &...

Thanks for the heads up. For some time I have been looking for an economical way to reconfigure/reduce the bulky dimensions of my Ruger RSM in .416 Rigby. It balances like carrying a 2" x 4". I will order one of these and whittle it down into something more hand friendly... Like the overall...