Knife Making Process
N

Knife Making Process

It can then be clamped to the second side of horn and the process is repeated. Mark the first hole and drill it through, pin and clamp to mark the second hole and drill it through. At this stage I can pin both pieces together and using a 120grit belt and the platen I can refine the front of the bolster then the tricky part is to do the inside curve on the back of the bolster using the 2 inch wheel at the top of the platen, making sure to keep it square to the belt as I go or as close to square as my eye will hold.
There are no comments to display.

Media information

Category
Weapon & Ammunition
Added by
nztimb
Date added
View count
377
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

 
Top