Getting ready to start load development on a new CZ 550 American in 9.3x62.
Standard FL RCBS dies, Lapua Brass and a box of factory Lapua (220 mono metal) ammo arrived today. Along with some 250 gr Nosler AB's and 232 gr Norma Vulkan bullets.
I typically use the Hornady Cartridge Headspace tool to get a feel for the shoulder setback measurements and then shoot for about .002" of cartridge headspace at the shoulder when sizing fired brass.
There is no bushing that works for the 9.3 in the standard Lock n Load kit and none available that I can find.
What do most re-loaders do (Re: shoulder setback) for the 9.3? Sounds like it might just be a "seat of the pants" thing like we did before such measuring tools were available??