225 grain Barnes TTSX  & TSX  Bullet Performance
Tommy Teas

225 grain Barnes TTSX & TSX Bullet Performance

Just back from my first hunt in Africa, this one for Plains Game. Hunting with HGR2 and his bride. Of a Sable, Kudu, Blue Wildebeest, Zebra, Eland and Mountain Reedbuck taken; these 3 were the only bullets recovered.

The 2 on the left are 225 grain Barnes TTSX, launched at 2,750FPS from a 338 WM. The first struck the point of the shoulder of a zebra quartering toward me, breaking the shoulder and stopping under the hide behind the diaphram on the off side. I figure it lost 3 petals while smashing the shoulder. The Zebra staggered about 25 yards before collapsing.

The second hit a few inches high and behind the shoulder of a broadside Sable. It was found under the skin of the opposite side. The Sabel stumbled about 50 yards before stopping, and I stuck another round through the boiler house.

The third bullet is a 285 grain Barnes TSX, which load I had worked up in case I decided to go after something bigger. We were after Eland, and I had the 285s loaded, when the Blue Wildebeest popped up. The round hit the on-side shoulder as he was quartering toward me, and came to rest against the pelvis on the other side of the midline. Apparently, the launch velocity of 2,300FPS was insufficient to cause expansion. It should be noted, however, that the animal dropped in his tracks, DRT. To be fair, I'm sure this bullet was developed with the 338 Lapua in mind, so I'm not too dissapointed that it acted as a solid, and did not expand at 338WM velocity.

As mentioned , the Wildebeest dropped in his tracks. So, unaware that it had failed to expand,I continued to stalk Eland with the 285s; taking a nice bull with that round later in the day. No bullets were recovered from the Eland. I guess that a 285 grain 338 "solid" is not that bad of a hunting bullet. <G>
Very interesting results! Thanks for posting and I’m glad you put the 285s in the right spot because IMO the bullets did not perform well. You may be very correct in your accessment they are designed for the 338 Lapua.

I’ll be watching each of my Barnes bullets in my slower cartridges for the same type of results. If your conclusion is correct, Barnes should indicate it on their boxes and website specs.

I loaded up 150gr 30 cal in my 30-06 to the same OAL as Vor-Tex factory only to discover an extra groove outside the case. Barnes told me they were designed for the 300WM and they didn’t have a component bullet for the 30-06 like the factory load. I don’t know if there is other structural differences and didn’t think to ask.

Thanks again for posting your findings!
 
One thing I like about Woodleigh is that they publish the working velocity for every bullet they sell.

The bullet that did not open may not have done so due to it having tumbled after entry. I've seen such bullets do the same before.
 

Media information

Category
Weapon & Ammunition
Added by
Tommy Teas
Date added
View count
1,649
Comment count
2
Rating
0.00 star(s) 0 ratings

Share this media

 
Top