Soft Point / Solid Combo for DG
This is a discussion on Soft Point / Solid Combo for DG within the Hunting Africa forums, part of the Hunting Forums - Hunting in Africa category; I've got a question concerning bullets for DG, specifically for Buffalo. I don't know when I'm going to get back ...
11-17-2010, 04:20 PM #1
Soft Point / Solid Combo for DG
I've got a question concerning bullets for DG, specifically for Buffalo. I don't know when I'm going to get back to Africa but when I do, I'd like to go after Buffalo. Shortly after getting back from my first safari this past summer, I bought a Model 70 in .375 H&H. With my hunting schedule in the fall, I've still not fired the gun, but that will change this weekend.
But my question concerns what bullets. Mostly what I read here on AH, is to use a soft point (I'm leaning towards Swift A-Frames or Nosler Partitions) with a solid for a follow up 2nd shot. Is the reason for the solid 2nd for a potential head shot at a charging bull? What if the bull doesn't charge? I've seen numerous videos where a shot buffalo doesn't charge, but maybe just runs a bit but still offers a follow up.
Just trying to understand better how and what to prepare for.
11-17-2010, 06:37 PM #2
My choice has been/will be either North Fork or TSX. I have not used the Swifts on buffalo but know people who swear by them. Of the three I would find the one that shoots the best with your choice of solids.
Some people that I respect and have killed way more buffalo than me do not use solids on buffalo. Others would prefer solids for the second shot.
The disadvantage of a solid is you will shoot shoot through a broadside shot and risk hitting another buffalo if you are hunting in a herd. A soft will penetrate a buffalo skull and the boss if needed. More than likely your follow up shot will be with the buffalo running in the other direction. A solid will penetrate deeper on a raking shot hands down.
If your rifle will feed the Barnes Banded solid it is a good choice. The pentration tests performed on the 300 grain 375 BBS were impressive to say the least.
Short story for me: TSX or North Fork soft, follow up with a Barnes Banded Solid. Shoot until it is either down and dead or you can no longer see it.
A lot of combinations will work, pick one and most important ,enjoy your hunt.
11-17-2010, 10:25 PM #3
- Member of SCI and PHASA
- Hunted South Africa and Zambia
- Spiral Horn Safaris has no Articles
- View Spiral Horn Safaris's Photos
I would recommend using the soft solid combination my reason for that is more often than not the a buffalo will be moving away from you and not towards.
There will certainly be a lot of brush in the way chances are that you might have everything but an open second shot with that being said you will have to thread a bullet trough and hit the buffalo on a countering away angle.
I can also recommend using the Barnes TSX bullets they outperform most when it comes to hunting in Africa especially on dangerous game. The Barnes Banded Solid FB should do just fine as well.
There will no doubt be other combinations and no one is wrong it is up to each person’s personal preference you must find a combination that works best for you! It might also be wise once you have decided on a Outfit to ask the PH that you will be hunting with as to his preference with regards to using soft’s and solids.
Louis van Bergen
11-17-2010, 10:42 PM #4
- Member of PHASA ; SCI ; DSC ; Eastern Cape Game Management Association ; PE Pistol and Rifle Club
- Hunted South Africa, Namibia, New Zealand
- KMG Hunting Safaris has no Articles
- View KMG Hunting Safaris's Photos
11-18-2010, 10:01 AM #5
- Member of Double Rifle Shooter's Society, Life NAHC, NRA,SCI
- Hunted Us, Canada,Zambia, Zimbabwe, South America
- View Articles by DUGABOY1
- DUGABOY1 has no Photos
The use of certain types of bullets IS a personal choice, but there are reasons that have nothing to do with choice for certain types depending on what type rifle you are using!
If, for instance, you are doing all your shooting with a bolt rifle, then just about any bullet recommended here would do the job if you do yours. However, if you are using a double rifle, then some types are not the best choice. With the choice of the bullet, the buffalo is not the only consideration to think about.
The Barnes solids are fine in single barreled rifles, but there are other solids that are better suited IMO. The solid that makes the difference is not what we think of as the traditional lead core solid, but the mono-metal solid. This includes the various so-called expanding solids that are mono-metal like the TSX, which has the bearing, surface that contacts the rifling being a solid mass of hard metal. The TSX with it’s pressure rings cut around the bearing surface is better than some of the earlier expanding solids like the X-bullet with a smooth bearing surface.
I must say here, however, that the pressure rings on the TSX are too wide, and are more likely to cause OSR (Over Stressed Rifling) than another type like the North Fork or the GS Custom, which have the pressure rings cut very thin, and the grooves between the rings deeper so the displaced metal of the pressure ring displaced by the rifling has someplace to go.
This is called a BORE RIDER type, and is far less detrimental to the barrel. As a rule the single barreled rifle that will be used for dangerous game will have far thicker walls than a double rifle, who’s walls are normally very thin. Top this off with the fact that the barrels are attached to the other barrel and the top and bottom ribs by solder, and the extra flex caused by a very hard bullet, my cause the separation of the barrels, or worse the permanent deformation of the barrel or barrels with OSR.
Most here will be using a bolt rifle, and in that case the solid bullet choice is easier, but if you are using a double rifle a little more though is recommended.
If I’m using a bolt rifle to hunt buffalo I place a North Fork soft point, Nosler partition, or Swift A-frame in the chamber followed by the same bullet as top cartridge in the magazine, followed with all solids down. In my double rifles I place a soft in the right barrel, and a solid in the left barrel. In all cases if I have a clear shot I place the first shot with a soft, followed by a quick soft in a bolt rifle, and followed by the solid in the left barrel in the double rifle. If I were hunting elephant I would opt for all solids, if hunting lion I would opt for all quality softs.
A buffalo will most times run a few steps forward at the first shot, then turn off , or swap ends and go straight away. In that case your not going to have time usually to get off more that one follow-up shot, and if it is quartering away, or straight away the solid has a better chance of getting into the vitals, and /or breaking large bones. If you have time for more than two shots, the rest of the magazine should be solids, and with the double the re-load should be all solids. If the buffalo charges then what ever is in the chamber needs to be utilized in short order, and here the old saying applies! “Once a cape buffalo puts together a concentrated charge, your options have been wonderfully simplified, you will kill him, or he will kill you!”
This also applies to lion, once he locks onto a target he will not be turned, and must be put out of service if you value your hide! Nothing short of a CNS hit will stop these two animals once they get going. A very hard slap in the face will often turn an elephant, but that counted on! SO what ever you load with the first shot is the telling action to finish the conflict, or start a fight. Ones the fight is on, the choice of bullets become a real factor.
So use you head when making this choice, and what ever you choose practice shooting the full magazine as fast, but as accurately as you can, at 25 yards, and count only the bullets that hit an 8 inch target. If using a double fire both barrels, and reload two more and fire those as well, and time all shots fired. You should get off four shots in about 5 seconds from a bolt rifle and four shot from a double rifle, with ejectors in about 4 seconds all on target.
Charges are rare with buffalo, unless wounded and being followed up. A charge from a wounded animal is far more likely with the cats, in Africa or brown bear in this country, than anything else in either place. However if it does happen, your pre-safari practice, and bullet choice will make the difference!DUGABOY1 www.doublerifleshooterssociety.com
"If I die today I have had a life well spent, for I have been to see the elephant, and smelled the smoke of Africa" qt by Damon(mac) McCartney
11-30-2010, 02:21 AM #6
I have always told my clients to use a soft for the first shot and a solid for the second but stopped doing that after numerous times the solid just whistled through the buffalo without doing much damage... A good soft will still penetrate and do a lot more damage, hit's much harder than a solid that just whistle's through the animal. And having had a few close calls on stray solids almost hitting other animals around the targeted animal I decided against it. (A solid hitting a rock or tree on a missed shot can go much further than any soft.)
With a good Partition bullet or Barnes TSX the penetration will still be good enough to break a hip or back of the buff when it is running away from you which is 90% of the time what happens after the first shot. I only recommend solids on rhino and elephant.
But at the end of the day as Louis said, ask your PH that you will be hunting with what he prefers and work from there as everybody has their own personal preferences.
I have hunted three times with HHK's Lou Hallamore in Zimbabwe. In his career he has killed more than likely over a thousand buffalo. He will swear to you soft points for the first round and solids after that. This can be read in his book, "In the Salt". I was in camp at Mokore safaris this past fall and the recommendations from Barry Duckworth, (who has probably shot as many buff as Hallamore) I believe is Solid, solid, and then another solid, (Mike70560 correct me if i'm wrong). And the debate goes on. My last buff was taken with a .416 with 400 gr. Swift A-Frames and Barnes solids. All five rounds were recovered.
12-01-2010, 06:41 PM #8
The softpoints were broadside and the first three shots and fired broadside and quartering as running away. The first solid was a running away shot put up the arse. The second solid was when he turned around to face me and put into the chest. The arse shot with the solid was found under the hide in the chest and the chest shot under the hide by the hind quarter. Both solids travelled the full length of the buff stopping just under the hide.
12-01-2010, 07:55 PM #10
By Da Mamba in forum Firearms & Ammunition GeneralReplies: 10Last Post: 01-29-2014, 01:41 PM
By DOC-404 in forum .375 & UpReplies: 102Last Post: 11-03-2012, 12:25 PM
By Shallom in forum Hunting AfricaReplies: 8Last Post: 05-23-2012, 11:10 PM
By ikeda in forum Hunting AfricaReplies: 7Last Post: 02-17-2011, 12:24 AM
By trigger creep in forum Hunting North AmericaReplies: 9Last Post: 12-15-2010, 02:13 PM